The ignition key must be in the key cylinder for cylinder removal. The key cylinder must be removed first before removing ignition switch.

REMOVAL
1. Disconnect negative battery cable at battery.
2. If equipped with an automatic transmission, place shifter in PARK position.
3. Rotate key to ON position.

Key Cylinder Release Tang

Click for full-size image
4. A release tang is located on bottom of key cylinder.

Key Cylinder And Cover Removal

Click for full-size image
5. Position a small screwdriver or pin punch into tang access hole on bottom of steering column lower cover.

INSTALLATION
1. If equipped with an automatic transmission, place shifter in PARK position.
2. Position key cylinder into steering column as it would normally be in the ON position.
3. Press key cylinder into column until it snaps into position.
4. Check mechanical operation of switch. Automatic Transmission: Be sure transmission lever is locked in PARK position after key removal. If key is difficult to rotate or is difficult to remove, the shift lever-to-steering column cable may be out of adjustment or defective. If key can be removed, release lever mechanism may be defective. Release lever mechanism is not serviced separately. If repair is necessary, the steering column must be replaced.
5. Connect negative cable to battery.
6. Check electrical operation of switch.

Operation	Task	Skill	Hours
Replace	With Tilt Wheel	B	0.6
Replace	Without Tilt Wheel	B	0.6

Ignition Switch Lock Cylinder