Document ID: 2203442

Removal Procedure

Warning: Refer to Brake Fluid Irritant Warning.

Caution: Refer to Brake Fluid Effects on Paint and Electrical Components Caution.

Caution: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.

Place the ignition switch in the OFF position.

Click for full-size image
Thoroughly clean the area around the electronic brake control module (EBCM) of all dirt and debris.
Disconnect the EBCM electrical connector.

Note: Note the brake pipe locations for proper installation.

Disconnect the rear brake pipe fittings (1) from the brake pressure modulator valve (BPMV).
Cap the brake pipe fittings and plug the BPMV outlet ports to prevent brake fluid loss and contamination.

Note: Note the brake pipe locations for proper installation.

Disconnect the front brake pipe fittings (1) from the BPMV.

Click for full-size image
Cap the brake pipe fittings and plug the BPMV outlet ports to prevent brake fluid loss and contamination.

Note: Note the brake pipe locations for proper installation.

Disconnect the master cylinder brake pipe fittings (1) from the BPMV.

Click for full-size image
Cap the brake pipe fittings and plug the BPMV inlet ports to prevent brake fluid loss and contamination.
Remove the BPMV nuts (1).

Click for full-size image
Remove the BPMV (1).

Click for full-size image
Remove the BPMV lower insulator (1).

Click for full-size image
Remove the BPMV insulators (1) and bushings (2).

Click for full-size image
Remove the EBCM. Refer to Electronic Brake Control Module Replacement.

Installation Procedure

Install the EBCM. Refer to Electronic Brake Control Module Replacement.

Click for full-size image
Install the BPMV insulators (1) and bushings (2).
Install the BPMV lower insulator (1).

Click for full-size image

Note: Ensure the BPMV is fully seated in the lower insulator.

Install the BPMV (1).

Click for full-size image

Caution: Refer to Fastener Caution.

Install the BPMV nuts (1) and tighten to 8 Nm (71 lb in).

Click for full-size image

Note: Note the brake pipe locations for proper installation.

Connect the master cylinder brake pipe fittings (1) to the BPMV and tighten to 23 Nm (17 lb ft).

Click for full-size image

Note: Note the brake pipe locations for proper installation.

Connect the front brake pipe fittings (1) to the BPMV and tighten to 16 Nm (12 lb ft).

Click for full-size image

Note: Note the brake pipe locations for proper installation.

Connect the rear brake pipe fittings (1) to the BPMV and tighten to 16 Nm (12 lb ft).

Click for full-size image
Connect the EBCM electrical connector.
Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding.
Perform the Diagnostic System Check - Vehicle.
Observe the brake pedal feel after performing the diagnostic system check. If the pedal now feels spongy, air may have been in the secondary hydraulic circuit of the brake modulator which may have been introduced into the primary circuit. If the pedal feels spongy, perform the Antilock Brake System Automated Bleed.

Hydraulic Control Assembly - Antilock Brakes