Document ID: 2174470

Removal Procedure

Disconnect the clutch master cylinder push rod (1) from the clutch pedal pin (2).

Click for full-size image
Remove the clutch fluid reservoir (1) hose from the clutch pedal assembly, then plug hose.

Click for full-size image
Disconnect the clutch actuator pipe assembly (2) from the clutch pedal assembly.
Remove the two clutch master cylinder fasteners (1) from the right side of the clutch pedal assembly.

Click for full-size image
Remove the two clutch master cylinder fastener (1) from the left side of the clutch pedal assembly.

Click for full-size image
Remove the clutch master cylinder (1) and the spacer (2) from the clutch pedal assembly.

Click for full-size image

Installation Procedure

Note: Hold the clutch pedal in the full up position when installing the clutch master cylinder. It may be necessary to use another person to ensure that the pedal is in the full up position.

Install the clutch master cylinder (1) and the spacer (2) to the clutch pedal assembly.

Click for full-size image

Caution: Refer to Fastener Caution.

Install the two clutch master cylinder fastener (1) to the left side of the clutch pedal assembly and tighten to 20 Nm (15 lb ft).

Click for full-size image
Install the two clutch master cylinder fasteners (1) to the right side of the clutch pedal assembly and tighten to 20 Nm (15 lb ft).

Click for full-size image
Connect the clutch master cylinder push rod (1) to the clutch pedal pin (2).

Click for full-size image
Connect the clutch actuator pipe assembly (2) to the clutch pedal assembly.

Click for full-size image
Connect the clutch fluid reservoir hose (1) to the clutch pedal assembly.
Check for proper clutch pedal movement and operation.
Bleed the hydraulic clutch system. Refer to Hydraulic Clutch System Bleeding.

Clutch Master Cylinder