Document ID: 2182298

Remove the rear fascia or rear bumper impact bar. Refer to Rear Bumper Fascia Replacement.
Disconnect the sensor harness.

Click for full-size image
Remove the sensor from the sensor housing.
The sensor bracket must be painted if replaced. If reinstalled, painting will not be necessary.
Sand/grind sonic weld plastic residue from the fascia.

Click for full-size image
Apply structural adhesive epoxy, Lord Fusor™ 127EZ or equivalent, to fascia at mating surface.

Click for full-size image
Using the alignment tabs, install the sensor housing to the fascia.

Click for full-size image
Allow adhesive to cure according to manufacturer's directions.
Install the sensor to the sensor bracket.

Click for full-size image
Connect the electrical harness.
Install the rear fascia. Rear Bumper Fascia Replacement.
Perform the necessary programming and setup procedures: Control Module References

Parking Assist Distance Sensor