REMOVAL

Accelerator Pedal Mounting

Click for full-size image
1. From inside vehicle, hold up accelerator pedal. Remove plastic cable retainer (clip) and throttle cable core wire from upper end of accelerator pedal arm. Plastic cable retainer (clip) snaps into pedal arm.
2. Remove cable core wire at pedal arm.
3. From inside vehicle, pinch both sides of cable housing retainer tabs at dash panel. Remove cable housing from dash panel and pull into engine compartment.

Throttle Cable Routing

Click for full-size image
4. Remove cable from clip guides on engine cylinder head (valve) cover.

Throttle Cable At Throttle Body - Typical

Click for full-size image
5. Remove throttle cable ball end socket at throttle body linkage (snaps off).
6. Remove throttle cable from throttle body mounting bracket by compressing retainer tabs and pushing cable through hole in bracket.
7. Remove throttle cable from vehicle.

INSTALLATION
1. Slide throttle cable through hole in throttle body bracket until retainer tabs lock into bracket. Connect cable ball end to throttle body linkage ball (snaps on).
2. Snap cable into clip guides on engine cylinder head (valve) cover.
3. Push other end of cable through opening in dash panel until retaining tabs lock into panel.
4. From inside drivers compartment, slide throttle cable core wire into opening in top of accelerator pedal arm. An index tab is located on pedal arm. Rotate and push cable retainer (clip) into pedal arm opening until it snaps in place on index tab.
5. Before starting engine, operate accelerator pedal to check for any binding.

Throttle Cable/Linkage