MAGNETIC CLUTCH DISASSEMBLY/ASSEMBLY [LF, L3]
1. Disassemble in the order indicated in the table.

Click for full-size image

2. Assemble in the reverse order of disassembly.
3. Adjust the magnetic clutch clearance. (See MAGNETIC CLUTCH ADJUSTMENT.)

Bolt Removal/Installation Note

Click for full-size image
1. When removing or installing the bolt, hold the pressure plate in place as shown in the figure.
2. When installing a new A/C compressor body, replace the recommended bolt.

Stator and Thermal Protector Removal Note
1. After removing the stator and thermal protector, completely remove the silicone adhering to the A/C compressor side.

Stator and Thermal Protector Installation Note

Click for full-size image
1. Apply approx. 1 g {0.04 OZ} of silicone (Shin-Etsu Silicone KE-347W or similar) to the contact surface of the thermal protector, then thoroughly install it onto the A/C compressor, leaving no gaps.

Screw Installation Note
1. When installing a new stator and thermal protector, replace the screw.

Clamp Installation Note
1. When installing a new stator and thermal protector, replace the clamp.

Snap Ring Installation Note

Click for full-size image
1. When installing a new pressure plate, A/C compressor pulley, stator, or A/C compressor body, replace the snap ring.

Compressor Clutch