WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, REFER TO AIRBAG AND SEAT BELTS/AIR BAGS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIR-BAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the glove box from the instrument panel. See: Glove Compartment > Procedures > Glove Box Component Replacement
Glove Box Latch Striker Remove/Install
Click for full-size image
3. Remove the two screws that secure the latch striker to the grab handle bezel at the top of the instrument panel glove box opening.
4. Remove the latch striker from the instrument panel.
INSTALLATION
1. Position the latch striker onto the instrument panel.
2. Install and tighten the two screws that secure the latch striker to the grab handle bezel at the top of the instrument panel glove box opening. Tighten the screws to 2.2 N.m (20 in. lbs.).
3. Install the glove box onto the instrument panel. Refer to Glove Box in the Service and Repair for the procedures.
4. Reconnect the battery negative cable.
Glove Box Components
Click for full-size image
Service of all of the glove box components must be performed with the glove box removed from the instrument panel.
WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, REFER TO AIRBAG AND SEAT BELTS/AIR BAGS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIR-BAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
REMOVAL
Glove Box Lock Cylinder
1. Disconnect and isolate the battery negative cable.
2. Remove the glove box from the instrument panel. See: Glove Compartment > Procedures > Glove Box Component Replacement
3. Remove the glove box latch and handle from the glove box.
4. Insert the key into the glove box lock cylinder.
Glove Box Lock Cylinder Remove/Install
Click for full-size image
5. Insert a small screwdriver into the retaining tumbler release slot and depress the retaining tumbler.
6. Pull the lock cylinder out of the glove box latch handle by using a gentle twisting and pulling action on the key.
INSTALLATION
Glove Box Lock Cylinder
1. Insert the key into the glove box lock cylinder.
2. Push the lock cylinder into the glove box latch handle by using a gentle twisting and pushing action on the key.
3. Install the glove box latch and handle onto the glove box.
4. Install the glove box onto the instrument panel. See: Glove Compartment > Procedures > Glove Box Component Replacement
5. Reconnect the battery negative cable.