1. Disconnect the negative battery cable.
2. Remove the inner garnish.
Click for full-size image
3. Disconnect the power outer mirror connector.
4. Remove the screws.
5. Push the power outer mirror against the vehicle and detach the tab while lifting the mirror up to remove.
6. Install in the reverse order of removal.
OUTER MIRROR GARNISH REMOVAL
1. Remove the mirror glass from the outer mirror.
Click for full-size image
2. Pinch the clip ends using pincers and detach the clips by pushing them forward.
3. Grasp the upper side of the outer mirror garnish and remove it by pulling it in the direction of the arrow.
OUTER MIRROR GARNISH INSTALLATION
Click for full-size image
1. Position the outer mirror garnish against the mirror body in the direction of the arrow shown in the figure, and insert the outer mirror garnish clips (6 locations) into the mirror body.
2. Install the outer mirror garnish so that there are no gaps around the component.
REARVIEW MIRROR REMOVAL/INSTALLATION
Click for full-size image
1. Insert a tape-wrapped flathead screwdriver into the notch and pry with the screwdriver in the direction shown by the arrow to remove the covers. (Vehicles with auto wiper system)
Click for full-size image
2. Remove the covers. (Vehicles with auto wiper system)
3. Remove the rain sensor. (Vehicles with auto wiper system)
Click for full-size image
4. Remove the clip, and then remove the rearview mirror upward.
5. Install in the reverse order of removal.