Brake Pedal Assy

Removal Procedure

1. Disconnect the brake pedal position sensor electrical connector.
2. Remove the power brake booster pushrod retainer bolt (1).
   
   Click for full-size image
   
3. Remove the power brake booster pushrod retainer (1).
   
   Click for full-size image
   
4. Remove the brake pedal assembly bolts (1).
   
   Click for full-size image
   
5. Remove the brake pedal assembly nuts (1).
   
   Click for full-size image
   
6. Disconnect the power brake booster pushrod from the brake pedal.
7. Release the electrical harness from the retaining clips on the brake pedal bracket assembly.
8. Carefully push against the power brake booster studs to position the power vacuum brake booster forward slightly.
9. Maneuver the brake pedal assembly from under the instrument panel and remove the brake pedal assembly from the vehicle.

Installation Procedure

1. Maneuver the brake pedal assembly into the installed position from under the instrument panel.
2. Position the power vacuum brake booster rearward.
3. Ensure the power vacuum brake booster studs engage the brake pedal assembly.
Caution: Refer to Fastener Caution.

4. Install the brake pedal assembly nuts (1) and tighten to  17 Nm (13 lb ft).
   
   Click for full-size image
   
5. Install the brake pedal assembly bolts (1) and tighten to  22 Nm (16 lb ft).
   
   Click for full-size image
   
6. Connect the power brake booster pushrod to the brake pedal pivot pin.
   
   Click for full-size image
   
7. Install the power brake booster pushrod retainer (1).
8. Install the power brake booster pushrod retainer bolt (1) and tighten to  9 Nm (80 lb in).
   
   Click for full-size image
   
9. Position the electrical harness to the brake pedal bracket assembly and secure to the routing clips.
10. Connect the brake pedal position sensor electrical connector.
11. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration.